2022+ Uconnect 5 Cargo Camera Posi-Tap Guide
If you have a Uconnect 5 system, then you will be receiving a pigtail adapter with a yellow RCA and two posi-taps. Red is the Camera Signal, and Black is the Camera Return.
You will be tapping to the Blue connector on the back of the radio unit. The Uconnect 5 has a few variations. If this is the Uconnect 5 UBD, then the blue connector will be on the back of the radio display. If the Uconnect 5 does not have the blue connector on the back of the display, then you likely have the UBL, or UBQ (These models specifically feature onboard navigation) and will need to follow the thick black cable from the back of the radio screen further into the dash, and that will lead you to the radio unit itself, where you can find the blue connector in the image below.
Tap Camera Signal (Red) to the Gray Wire with a Blue stripe.
Tap Camera Return (Black) to the Gray wire with a Yellow Stripe.
Related Articles
Cargo Camera Icon
"My cargo camera icon is not showing up, but I got a green light when I used the OBDGenie?" Perform a can-bus reset. CAN-bus Reset: Remove positive and negative cables from the vehicle battery. Touch and hold the cables together for 5 - 10 seconds. ...Custom Genuine MOPAR Tailgate Camera BCM Posi-Tap Guide
When installing the Custom Genuine MOPAR Tailgate Camera upgrade, in order to obtain the dynamic guidelines, the BCM has to be tapped into. For reference, here is a photo of all of the parts included with this kit, and where the connections go. The ...GMC Amp Power Tap
GMC Amp Power Tap For some vehicles when upgrading to a radios that needs an amp for increased volume you'll need to tap into the thin pink wire on the amp harness (G-INTAMP). You can tap into the thin pink wire at the amp or at the radio. We ...Cargo Camera - Grid Lines
To turn off Grid Lines for a RAM Cargo Camera: You will need to snip the green wire, this might be labeled "Parking Lines". If you are still seeing the grid lines (parking lines) after snipping the green wire or if the green wire is already snipped, ...2019-2022 Ram Heavy Duty Truck Factory OEM Remote Start Upgrade Posi-Tap Guide
First disconnect the battery, both batteries if the vehicle has two. Next is locating the BCM to pin the cable from the hood latch harness. The BCM is located to the left of, and behind the steering wheel. You may need to remove the left sill and ...