AC Climate control visual bug on Ram 1500

AC Climate control visual bug on Ram 1500

Parts Required

Two Genies labeled LD, and DS
Wire connector that you will use to connect the sensor
Temperature Sensor
Security bypass if you are an 18+ year


Installation

Attach the sensor wire to the open molenex connector on the harness that is running to the HVAC. You should see the connection there as it will be unused, and is right near the HVAC. Once you have the sensor connected you are going to route it to the drivers side, and place it under the dash bezel there. I will try to get a video explaining this, so it is easier to follow.  

 Sensor Installation Location

You will want to run the genie labeled LD first, and once you get a green light from that let the vehicle rest for a few minutes. Wait until you see and dual-zone configuration (indicating the first genie finished programming) then use the second genie. You will run the DS programmer second, and once you get the green light with that you can go ahead, and let the vehicle sleep as your issue should now be fixed.

*********************************************************************** 18 + Vehicles only *********************************************************************

With certain 2018 + Vehicles you will need to use our security bypass module to properly program the vehicle using our OBD Genie. You will connect our security bypass to the existing security module in your vehicle by taking the two wires out of the factory installed security module, and connecting them into our security bypass. Once our bypass is installed you can than run the OBD Genie. Once you get a green light from the genie you can take our bypass off, and connect the wires back into the factory security module. The vehicle will have programmed successfully, and you can now enjoy your new upgrade!


                                    18 RAM Module Location                                                                                           19 RAM Module Location
                

    • Related Articles

    • Can't control climate on 8.4 Jeep Wrangler screen upgrade

      Can't control climate on 8.4 Jeep Wrangler screen upgrade After installing an 8.4 inch screen upgrade, if you've noticed that you can control your climate on the hard knobs but not the touchscreen, it's because your stock climate control is analog. ...

    • 2019 Heavy Duty UAV or UAX Upgrade Climate issue

      Since last year we've had an issue where a 2019+ Ram truck customer (who has installed either a UAV or UAX upgrade) increases or decreases their cabin temperature around 70-74 degrees the vehicle either goes full heat or full cold. This happens ...

    • Ford 4" to 8" - Fan Does Not Work

      If you are unable to get your fan / blower to work with you AC / Climate, this is indicative that something was not hooked up correctly. Most likely the wrong wire was used when getting power from the ignition. There might be multiple white / orange ...

    • 2016+ Grand Cherokee HVAC Climate Control Swap

      2016+ Grand Cherokee HVAC Climate Control Swap Button Swap Instruction Video: Do you own a 2016+ Jeep Grand Cherokee with an existing 8.4-inch Uconnect radio? Did you know you can easily upgrade to the all-new 8.4-inch "UAV" Uconnect Infotainment ...

    • Security Bypass Module location & instructions

      If you have a 2018+ Chrysler, Dodge, Ram or Jeep Vehicle, you will need to temporarily install a Security Bypass Module: https://www.infotainment.com/products/fca-security-gateway-module-bypass The security bypass module is plugged into the vehicle, ...