BATTERY/BCM DRAINAGE EXPEDITION 4 to 8 Sync 3 Upgrade Kit
Are you experiencing battery drainage or your BCM does not sleep after the vehicle is turned off?
Make sure that you are running the power to an ignition source as seen on the installation video. The same plug that will run to an ignition source is the single extended cable that is connected to the harness that will also connect to the new HVAC. Please reference the photo below showing the harness.
Installation Video: Please forward to 7:05 mins of the video to see the harness.
If you've received a harness and it does not have that connection please click the link "Create A Ticket" from our support page on our website and attached a photo of the harness that you received explaining the issue. A representative will contact you within the next 24 hours.
Related Articles
Time won't set for non-Nav Sync 3
Despite not having navigation programmed to the APIM module, for the non-Nav version of Sync 3 upgrades, all APIMs use a GPS antenna to set time. If time will not stay, when set, check your GPS antenna and make sure it's plugged into the ...RADIO DOES NOT POWER ON AFTER I INSTALL MY UPGRADE KIT
If you installed your upgrade kit and notice that your radio no longer turns on please check the followings: 1. If you received a C-INT-C4T (the big harness that connects to the radio and existing power harness) in your kit, make sure that the white ...Brick Kit XP2 Harness not getting secure connection for Sync
In some rare circumstances, the Sync harness when being pinned with the XP2 harness, voice recognition and Sync may not operate properly. This is mostly due to the XP2 harnesses pins not making a secure connection to the receptacle that the Sync ...Ford Mustang 4" to 8" Sync 3 Upgrade: "I'M MISSING CABLES FROM MY KIT"
If you've purchased the Ford Mustang 4" to 8" Sync 3 upgrade and watched our installation video you may see that there are two small cables that are mentioned and is missing from your kit. We are sorry for the confusion, but we've improved our kit to ...Sync 3 upgrade gives Navigation Fault
This issue arrives if the Sync 3 upgrade doesn't have our infotainment GPS antenna plugged in upon start-up: To resolve this, always plug in the GPS antenna we supplied you BEFORE turning on the unit/vehicle.