Brick Kit XP2 Harness not getting secure connection for Sync
In some rare circumstances, the Sync harness when being pinned with the XP2 harness, voice recognition and Sync may not operate properly. This is mostly due to the XP2 harnesses pins not making a secure connection to the receptacle that the Sync Harness connects to. The Sync Harness's housing is the root cause of this, so removing the housing and securely plugging the Sync Harness into its receptacle WITHOUT the Sync Harness Housing allows a proper connection.
This is the housing Remove by pulling the sides outwards and sliding the connector out
Plug this connector without the housing directly to port
Related Articles
BATTERY/BCM DRAINAGE EXPEDITION 4 to 8 Sync 3 Upgrade Kit
Are you experiencing battery drainage or your BCM does not sleep after the vehicle is turned off? Make sure that you are running the power to an ignition source as seen on the installation video. The same plug that will run to an ignition source is ...Diagram for Denso Amp and GM XM diagram kit
Diagram for Denso Amp and GM XM diagram kitGMC Amp Power Tap
GMC Amp Power Tap For some vehicles when upgrading to a radios that needs an amp for increased volume you'll need to tap into the thin pink wire on the amp harness (G-INTAMP). You can tap into the thin pink wire at the amp or at the radio. We ...Ford Mustang 4" to 8" Sync 3 Upgrade: "I'M MISSING CABLES FROM MY KIT"
If you've purchased the Ford Mustang 4" to 8" Sync 3 upgrade and watched our installation video you may see that there are two small cables that are mentioned and is missing from your kit. We are sorry for the confusion, but we've improved our kit to ...Sync 4 Screen is Glitchy / Back-up Camera Does not appear in Reverse
Problem: Customer's Sync 4 display screen is glitchy or the backup camera does not appear when in reverse. Possible Resolution: Disconnect the supplied harness and reconnect to the factory plugs. Ensure the yellow RCAs are securely connected. Test ...