C-INTC3T RE2 RB5 Camera Repinning Guide

If your RB5 or RE2 radio already has the C3 connector with populated wires like the photo below, you will not be able to use our connector because you will lose audio and microphone for bluetooth functions.

You will need to do a re-pinning procedure to add Camera Signal and Camera Return to your factory connector.

The connector provided will have to be de-pinned and repinned to the factory connector circled in yellow above. The two pins, 15 for Camera Signal and 16 for Camera Return will not be on the factory connector, they will be vacant. Once the two wires are depinned from our connector, they can easily be inserted into the factory connector. Please use the pictures below for reference. Mating side is what touches the radio, the wire insertion side is where you'll be pushing them into on the factory connector.

The RED wire will pin to 15, and the BLACK wire will pin to 16.

• Related Articles

• C-INTC2T Mygig Camera Repinning RER RHR REN RBZ RHB

  This is for vehicles that have a Mygig style radio. Such as RER/RHR/REN/RBZ/RHB and the white plug already exists behind the radio. You will not be using our connector provided, you will need to de-pin the 2 wires from our connector, and then pin ...

• IOU Upgrade Backup Camera TSB

  On some model Silverado trucks the backup camera mounting location needs to be modified to accept the new camera included in the upgrade. If attempting to install the new camera into the tailgate handle, and you run into an issue where the camera ...

• Cargo Camera Icon

  "My cargo camera icon is not showing up, but I got a green light when I used the OBDGenie?" Perform a can-bus reset. CAN-bus Reset: Remove positive and negative cables from the vehicle battery. Touch and hold the cables together for  5 - 10 seconds. ...

• "Service Rearview camera" error after installing GM back up camera

  Once confirming you're pre-wired in a 15 model vehicle or installing the camera in a 16 year vehicle or newer, you'll typically want to install the camera wiring into the dummy plug. However, those who have a locking tailgate handle be sure to swap ...

• Hardmount C-SATF-DT Skarkfin Antennas on Heavy Duty Rams

  The C-SATF-DT antenna will not fit on Heavy Duty Rams. In this case, the existing sharkfin antenna can stay and only need U-INTC2K