Can't Find Address with UAX On-Board Navigation
Can't Find Address with UAX On-Board Navigation
This happens if you're trying you're trying to input addresses in the learn search bar at the top of the Navigation screen.
This bar is for 4G signal (Internet Search), not GPS, so you'll get an error message when trying to use it.
Instead make sure you always utilize the "Where To" icon for GPS routing.
From there you can search for an address to navigate too.
Related Articles
Time won't set for non-Nav Sync 3
Despite not having navigation programmed to the APIM module, for the non-Nav version of Sync 3 upgrades, all APIMs use a GPS antenna to set time. If time will not stay, when set, check your GPS antenna and make sure it's plugged into the ...
Sync 3 upgrade gives Navigation Fault
This issue arrives if the Sync 3 upgrade doesn't have our infotainment GPS antenna plugged in upon start-up: To resolve this, always plug in the GPS antenna we supplied you BEFORE turning on the unit/vehicle.
MyGIG radio GPS won't allow me to type further than a few letters
MyGIG radio GPS won't allow me to type further than a few letters In the MyGIG radios, GPS is predictive and will auto-fill options as you try to type in addresses. If the GPS doesn't allow to you to go further than a few letters, the address you're ...
2019 Heavy Duty UAV or UAX Upgrade Climate issue
Since last year we've had an issue where a 2019+ Ram truck customer (who has installed either a UAV or UAX upgrade) increases or decreases their cabin temperature around 70-74 degrees the vehicle either goes full heat or full cold. This happens ...
The navigation display doesn’t accurately follow me down the highway/Issue with hearing turn-by-turn directions
The navigation display doesn’t accurately follow me down the highway/Issue with hearing turn-by-turn directions If you're having any of the issues below, you may need to install the VSS kit (brown connector) which should have been included in your ...