Colored FAKRAs/Connectors behind all Chrysler/Dodge/Jeep radios and modules

- White; is AM/FM.

- Blue; is GPS/Compass. (Only on units not compatible with  

- Yellow/Curry; is SiriusXM. (You might find a yellow connector if you remove the blue pigtail on the new unit. Depending on the vehicle, you may find only a yellow port which is for a dual antenna GPS and SiriusXM combined)

- Purple; is 911 Assist which is not required.

- Red; is for diagnostics.

- Pink; is not mapped to anything. (It routes to vehicles antennas in specific vehicles outside of the USA.)

- Green and Orange are sometimes featured, but not required unless you already have those connections in your vehicle.

- Gray Mini USB is for your USB Hub.

- Black; is for FM2 (Specific for certain countries.)

- Grey; DAB (Specific in European, Middle Eastern and Oceanic countries)

​

- The large, black harness is the main power harness.

For the most part, just match everything by color. The only exception would be when it comes to Blue and Yellow.

• Related Articles

• FCA - Restoring Vehicle Configuration

  How to restore vehicle configuration (Step by Step)  1. From the Vehicle Select Screen, navigate to the Vehicle Topology Screen or Electronic Control Unit (ECU) List  2. Select Body Control Modules (BCM)  3. From the BCM Screen, select the MISC ...

• DIFFERENT VEHICLE LOGO AND MISSING ICONS

  If you just installed your infotainment system and is getting a different splash logo. For example; your vehicle is a Jeep Wrangler but the radio shows Ram, that is completely normal and for all FCA vehicles. The radio will eventually adjust itself, ...

• RA4/RA3 troubleshooting steps

  RA4/RA3 Radio unit won't power on? After installing your 8.4 RA4 or RA3 head unit, and turning on your vehicle, you should get a splash screen right away. If your screen is completely black, with no backlight, with the engine on, put your ear near ...

• 2014-2017 Jeep Grand Cherokee 8.4-Inch RA4 Install

  Please click this link to view the product details Attached below is the product manual for this unit Troubleshooting:  "Radio Locked, Please Start Vehicle" error message explained. If you're having additional issues, try some additional ...

• Q: I installed the C-ACC-LD OBD Genie programmer in my 2011-2014 Chrysler 300 / Dodge Charger to enable AUTO temperature control and it's not working.

  Q: I installed the C-ACC-LD OBD Genie programmer in my 2011-2014  Chrysler 300 / Dodge Charger to enable AUTO temperature control and it's not working. A: If the programmer's embedded LED turned green then the vehicle's computer has been programmed. ...