Dealer Can't Find RSM Code to Add Travel Link to Radio Upgrade

Dealer Can't Find RSM Code to Add Travel Link to Radio Upgrade

The Dealer will have to call Sirius Tier II Support and get an authentication code from them, before they'll be allowed to see the RSM code in Dealer Connect. After that, they'll be able to use a Scan Tool to add the feature to the vehicle's BCM.

Vehicles upgrading from an RA4 going to a UAQ will not need this programming, as the factory BCM coding already has RSM. Also, any vehicle upgrading TO an RA4, will not need the programming because the RA4 also has RSM built into the radio unit. This would only need to be performed if the factory unit did not have RSM.

We carry this OBDGenie for vehicles that went from a radio incapable of Travel Link when upgrading to a Uconnect 4 system.
    • Related Articles

    • Dealer Mode

      Method 1: Hold down the bottom corners of the touch screen for another way to enter dealer mode. Method 2: STEP 1: • Put the system into ‘Dealer Mode’ • Hold the Driver Side Temp Up and Temp Down and Front Defrost buttons down at the same time for ...
    • Frequent Weather Alerts

      Frequent Weather Alerts You may notice weather alerts popping up on the radio during driving. This is a feature within Sirius Travel Link and, according to Sirius and Fiat-Chrysler, cannot be disabled. Currently the only way to disable these messages ...
    • "Radio Locked Please Start Vehicle"

      "Radio Locked Please Start Vehicle" If you are receiving this message, then you have either a Chrysler 200, Jeep Cherokee, Jeep Renegade or a Jeep Compass. These two vehicles use a Fiat based computer system and will need to have the vehicle's ...
    • BATTERY/BCM DRAINAGE EXPEDITION 4 to 8 Sync 3 Upgrade Kit

      Are you experiencing battery drainage or your BCM does not sleep after the vehicle is turned off? Make sure that you are running the power to an ignition source as seen on the installation video. The same plug that will run to an ignition source is ...
    • RADIO DOES NOT POWER ON AFTER I INSTALL MY UPGRADE KIT

      If you installed your upgrade kit and notice that your radio no longer turns on please check the followings:  1. If you received a C-INT-C4T (the big harness that connects to the radio and existing power harness) in your kit, make sure that the white ...