Ford 4" to 8" - Fan Does Not Work
If you are unable to get your fan / blower to work with you AC / Climate, this is indicative that something was not hooked up correctly. Most likely the wrong wire was used when getting power from the ignition. There might be multiple white / orange wires, so try using a different wire. You should verify that you are getting at least 12 volts with the key on.
Related Articles
Time won't set for non-Nav Sync 3
Despite not having navigation programmed to the APIM module, for the non-Nav version of Sync 3 upgrades, all APIMs use a GPS antenna to set time. If time will not stay, when set, check your GPS antenna and make sure it's plugged into the ...AC Climate control visual bug on Ram 1500
Parts Required Two Genies labeled LD, and DS Wire connector that you will use to connect the sensor Temperature Sensor Security bypass if you are an 18+ year Installation Attach the sensor wire to the open molenex connector on the harness that is ...Can't control climate on 8.4 Jeep Wrangler screen upgrade
Can't control climate on 8.4 Jeep Wrangler screen upgrade After installing an 8.4 inch screen upgrade, if you've noticed that you can control your climate on the hard knobs but not the touchscreen, it's because your stock climate control is analog. ...Ford F150 USB Hub Install
2016 Ford vehicles's need a USB media hub swap to get Apple CarPlay and Android Auto working. Here is the install for an F-150. F-HUB-SML F-HUB-R3 F-HUBBATTERY/BCM DRAINAGE EXPEDITION 4 to 8 Sync 3 Upgrade Kit
Are you experiencing battery drainage or your BCM does not sleep after the vehicle is turned off? Make sure that you are running the power to an ignition source as seen on the installation video. The same plug that will run to an ignition source is ...