Ford Mustang 4" to 8" Sync 3 Upgrade: "I'M MISSING CABLES FROM MY KIT"

Ford Mustang 4" to 8" Sync 3 Upgrade: "I'M MISSING CABLES FROM MY KIT"

If you've purchased the Ford Mustang 4" to 8" Sync 3 upgrade and watched our installation video you may see that there are two small cables that are mentioned and is missing from your kit. We are sorry for the confusion, but we've improved our kit to hopefully make your installing experience a little better. You no longer need the two short cables and should have received one long USB cable with two male ends (See the photo below).  


 

INSTALLATION

    
You are going to connect the new USB cable from the back of the APIM (attached behind the radio screen) to the media hub USB port. 

   
You no longer need the grey plug as seen below. You can leave it hanging or zip tie it. 

   
You no longer need the female plug that was attached to the original media hub as shown below. 



*All you need to install the media hub located in the middle console is the power and ground harness along with the USB cable with the two male ends.
 











 





    • Related Articles

    • Time won't set for non-Nav Sync 3

      Despite not having navigation programmed to the APIM module, for the non-Nav version of Sync 3 upgrades, all APIMs use a GPS antenna to set time. If time will not stay, when set, check your GPS antenna and make sure it's plugged into the ...
    • "Key Not Detected" message in cluster and can't start vehicle in 2015+ Ford Mustang, after installing Sync 3 upgrade

      All Mustangs 2015 year or newer are push to starts. The main antenna for the push to start is located in the center console. You'll run into this symptom if you unplug that antenna and don't return it before finishing installation.
    • Sync 3 upgrade gives Navigation Fault

      This issue arrives if the Sync 3 upgrade doesn't have our infotainment GPS antenna plugged in upon start-up: To resolve this, always plug in the GPS antenna we supplied you BEFORE turning on the unit/vehicle.
    • BATTERY/BCM DRAINAGE EXPEDITION 4 to 8 Sync 3 Upgrade Kit

      Are you experiencing battery drainage or your BCM does not sleep after the vehicle is turned off? Make sure that you are running the power to an ignition source as seen on the installation video. The same plug that will run to an ignition source is ...
    • Ford Sync 1 - Sync and Satellite Radio Issues

      If you do not have Sync - You will not gain (Sync) Bluetooth handsfree calling by upgrading to the Sync 1 GPS navigation radio. A factory-installed Sync module with wiring is required which cannot be added after-factory. If you have Sync but not ...