GMC Amp Power Tap

GMC Amp Power Tap

GMC Amp Power Tap

For some vehicles when upgrading to a radios that needs an amp for increased volume you'll need to tap into the thin pink wire on the amp harness (G-INTAMP). You can tap into the thin pink wire at the amp or at the radio. We recommend tapping into the thin pink wire at the radio using a posi tap to a 12 volt source. We use our 12v Power Accessory Interface (U-INTEZDC). 

G-INTAMP



Posi tap into the thin pink wire. 


Posi tap to the thin pink wire going to the rear of the radio on our harness. 


This is how the posi tap will look once clamped down. 


You can also tap into the thin pink wire at the amp side of our amp harness. We recommend tapping into the radio side. 





    • Related Articles

    • RADIO DOES NOT POWER ON AFTER I INSTALL MY UPGRADE KIT

      If you installed your upgrade kit and notice that your radio no longer turns on please check the followings:  1. If you received a C-INT-C4T (the big harness that connects to the radio and existing power harness) in your kit, make sure that the white ...
    • 2022+ Uconnect 5 Cargo Camera Posi-Tap Guide

      If you have a Uconnect 5 system, then you will be receiving a pigtail adapter with a yellow RCA and two posi-taps. Red is the Camera Signal, and Black is the Camera Return. You will be tapping to the Blue connector on the back of the radio unit. The ...
    • Diagram for Denso Amp and GM XM diagram kit

      Diagram for Denso Amp and GM XM diagram kit
    • Denzo shows splash screen, then blue screen with clock

      Denzo shows splash screen, then blue screen with clock When turning on the vehicle, if your Denzo headunit give you the GMC splash screen, then gives you a blue screen with just the clock on it, no allowing you to navigate further, try the below ...
    • IOR to IOU 7" to 8" Power and Ground Solution

      If the supplied conversion harness for the screen harness is not resulting in power to the display, there is another place to Posi Tap the harness to get power and ground to the screen. Further down on the back of the bezel will be a connector for ...