Outside temperature is incorrect
My Outside temperature stays at 32 degrees!
***************************************************************************************************************************************************************************
If
you are seeing your outside temperature display at 32 degrees, and is not
adjusting, do not worry for this is normal on a GM vehicle. When you disconnect
the battery for any reason it can take a while for the outside temperature
gauge to re-adjust and display the correct temperature.
This
issue should be fixed within 24-48 hours, so if you are not seeing it within a
few hours just let the vehicle go through a sleep cycle, or two (having the
vehicle off, and left alone overnight), and you should be seeing that function
properly after.
Related Articles
GMC Amp Power Tap
GMC Amp Power Tap For some vehicles when upgrading to a radios that needs an amp for increased volume you'll need to tap into the thin pink wire on the amp harness (G-INTAMP). You can tap into the thin pink wire at the amp or at the radio. We ...
Genie not programming for IOU upgrade
The vehicle must ALWAYS be in Accessory Mode for one minute, before placing your OBD Genie into the OBDII port, as the Genie can't be read by your vehicle when it's running. However, if the Genie programming is unsuccessful, with navigation not ...
Direction, and Temperature not at the top of the radio!
If you are looking at pictures of an RA4/UAQ screen you may notice some of them show direction, and temperature at the top of the screen. This was something that was actually removed with an update, and will no longer be displayed there. The reason ...
Outside Temperature Showing 0 C or 32 F
Please drive the vehicle. The air blows through the sensor in front of the radiator and the outdoor temperature will adjust itself.
GM Wireless Charger NOT WORKING
If your genuine GM wireless mobile phone charger it's not working please follow the steps below: 1. Ensure the phone is properly placed. The bottom of the phone should be on the pad. It is perfectly normal for the process to take up to 10 seconds ...