How To Soft Reset RA2

How To Soft Reset RA2

If you are experiencing any issues with your system the first thing to do is a soft reset. 

This is similar to doing a soft reset on your cell phone.  


1) Put your vehicle into the accessories mode (ACC or RUN) **For key-less start (push-button) vehicles: push the start button twice without having your foot on the gas or brake pedal**

2) Hold down the Phone and voice recognition buttons (or the volume and tuner buttons on your radio), at the same time, for thirty seconds

3) Let go of the buttons

4) Turn vehicle off

5) Open driver’s side door for thirty seconds

6) Close door

7) Restart vehicle

8) Let the media center load up and see if concern is still present

    • Related Articles

    • Sync 3 Soft Reset

      To Soft Reset your Sync 3 system; SIMULTANEOUSLY (at the same exact time) press the Scan Forward button (>>) and the CENTER power button (audio system power) and HOLD them in for a little more than 10 seconds.

    • How To Soft Reset SYNC 3

      A soft reset will resolve many different issues.   Press the Settings icon, then press on System and scroll down to the Master Reset option. This will master reset the unit.  

    • Master Reset for Dodge Charger/Challenger ONLY

      BEFORE ATTEMPTING A MASTER RESET PLEASE MAKE SURE THAT YOU'VE HAD THE UNIT INSTALLED IN YOUR VEHICLE FOR AT LEAST 48-72 HOURS. MOST ISSUES WILL BE FIXED IN TIME AS YOUR VEHICLE IS ADJUSTING TO THE NEW SYSTEM. A master reset only works for Chargers ...

    • Issues with a Refurbished RBZ unit / Canbus Reset

      If you recently purchased a refurbished RBZ and are having operational issues, such as wavy lines, a yellow/purple tinted screen, or the unit powers itself off and on, please try the following reset process: Radio/canbus reset: •Remove positive and ...

    • RER & RHR Engineering Mode (Resetting the radio)

      RER and RHR Engineering Menu: SEEK UP/DOWN and MENU, then click Accept at the warning screen. DO NOT DO A SCREEN CALIBRATION UNDER ANY CIRCUMSTANCES Go down a page or two, and you should see "Factory Default Reset" or "Factory Reset" and after ...