If you cannot locate an install video for your exact vehicle you can use this guide below.
There are YouTube video's other users have posted to show how to remove the dash bezel you may find.
The installation is a simple process though. If you cannot find a video on how to remove the dash bezel please refer to the Haynes or Chilton manual for your vehicle or contact your dealer service department or a professional installation company for assistance.
SYNC 2:
•Remove bezel around radio screen.
•There is four screws holding the radio on, remove these and pull out your screen/apim module.
•Remove the screws on the back of the apim module attached to the screen.
•Pull off the apim module.
•Reattach the new apim to the screen.
•Reinstall screws.
•Remount apim/screen .
•Reattach bezel.
SYNC 3:
•Remove bezel around radio screen.
•There is four screws holding the radio on, remove these and pull out your screen/apim module.
•Install the new apim and screen and plug in.
•Plug the GPS antenna into the blue port on the apim.
•Position the GPS antenna somewhere under the dash where no metal is covering it and it’s laying flat.
•Reinstall the bezel around the screen.
•Insert the NAV SD card.
Click here for direct access to our YouTube channel as you may find your vehicle.