Cargo Camera - Blue / Black Screen

Cargo Camera - Blue / Black Screen

If you are experiencing problems with your cargo camera and if you are getting a blue screen please make sure to follow the steps below. 



 PROPER CONNECTIONS. 


1. Make sure that you have the proper connections. 

     *If you have a factory rear camera then make sure that the the two yellow RCA plugs are connected on the T- Harness . It's going to say Cam In and OEM Cam Out. 

     *If you are adding the cargo cam then make sure that you are connecting the Cargo Cam RCA plug to the Blue RCA plug labeled Cargo Cam Input.

    • Related Articles

    • Cargo Camera Icon

      "My cargo camera icon is not showing up, but I got a green light when I used the OBDGenie?" Perform a can-bus reset. CAN-bus Reset: Remove positive and negative cables from the vehicle battery. Touch and hold the cables together for  5 - 10 seconds. ...
    • RA3 / RA4 Factory Cargo Camera w/ Backup Camera - Black / Blue Screen

      If a customer is using our backup camera and radio with a factory backup camera: 1. Verify that they have 17.11.07 SW Version 2. MAKE SURE THE MALE, YELLOW RCA ON THE HARNESS IS CONNECTED TO THE FEMALE, BLUE RCA ON THE HARNESS. 3. Verify that the ...
    • IOB Genie gave green light but screen is black

      This Genie puts the radio into sleep mode while it's programming. This means, after the Genie gives a green LED light, if it's pulled out immediately, the radio screen will stay black.  After turning on the vehicle's engine, letting it run 1 minute, ...
    • IOU has blue screen and Cadillac splash after install

      This is completely normal, as the screen will be blue, count down then give a Cadillac splash screen upon install install. This will not correct itself until the vehicle is restarted.
    • Lockpick - Blue / Black Screen

      How do you have the camera connected to the rear camera interface? The camera yellow video plug will plug into the yellow RCA plug on the big 52 pin harness labeled camera input. Check the ARC box, pop off the top and make sure the dip switches in ...