io6 Install Instructions for 2015 Colorado/Canyon
Below you can find some additional information on an io6 upgrade for a 2015 Colorado/Canyon.
You can see the store page by clicking here.
The picture above shows the location of where the HMI module is located.
The picture below shows a 3D model of the dash as a reference point.
Attached are two PDF files that show some additional information about the unit.
The first file (INST95) should be used as a reference point in assistance in removing the dash,
while the second PDF (2015MyLinkDetails..)simply shows additional information about the io6 module and it's capabilities.
Related Articles
Enzo C-INT4CK Instructions
FCA Heated and Ventilated Seat including Heated Steering Wheel Emulator (C-INT4CK) For those who upgrade to the 8.4" radio and their heated/cooled seats & heated/cooled steering wheel in the new radio are grayed out, we have a solution. Example of ...Security Bypass Module location & instructions
If you have a 2018+ Chrysler, Dodge, Ram or Jeep Vehicle, you will need to temporarily install a Security Bypass Module: https://www.infotainment.com/products/fca-security-gateway-module-bypass The security bypass module is plugged into the ...2015 Chevrolet Colorado MyLink® IO6 Upgrade HMI Location
The HMI is located behind the screen, and under the ACM, in this vehicle. After removing the other parts to gain access, simply replace the HMI module with your new one and reseat connectors.Genie not programming for IOU upgrade
The vehicle must ALWAYS be in Accessory Mode for one minute, before placing your OBD Genie into the OBDII port, as the Genie can't be read by your vehicle when it's running. However, if the Genie programming is unsuccessful, with navigation not ...15 Charger/Challenger USB hub Install/removal
These are instructions provided by a customer for an easier install/removal of the USB hub than the removing the entire console. USB Hub Removal/Install For a Charger, the swap of the hub is MUCH easier. While the same may apply to the Challenger, I ...