IOB Genie gave green light but screen is black
This Genie puts the radio into sleep mode while it's programming. This means, after the Genie gives a green LED light, if it's pulled out immediately, the radio screen will stay black.
After turning on the vehicle's engine, letting it run 1 minute, placing the OBD Genie in the OBD II port, and getting a green light, leave it in the port for 10 minutes for a full programming that will give your head unit a picture again.
Related Articles
OBD Genie App
OBD Genie App for C-RVC only To use the app to refresh the genie for Rear View Camera programming follow the steps below. 1. Download the OBD Genie Troubleshooting App on a iPhone or iPad. (App only works on Apple phones/pads) OBD Genie ...
OBD Genie Troubleshooting Guide
OBD Genie Troubleshooting Guide Following this simple instructions is the first steps to getting you back on the road with all the new modifications. My OBDGenie is not doing anything. No lights appear when plugged in, I can't tell if it's getting ...
UAX / UAV doesn't give display
UAX / UAV doesn't give display After installing your UAX or UAV upgrade, if you notice that you have a black screen. This is caused by one of two issues: The Genie didn't produce a green LED to properly program the vehicle to turn on the radios ...
There's no option to toggle off Daytime Running Lights after using OBD Genie
There's no option to toggle off Daytime Running Lights after using OBD Genie In North America, any Chrysler-based vehicle that's of 2015 year or older no longer has the ability to toggle off Daytime Running Lights. This is whether the feature was ...
Q: I installed the C-ACC-LD OBD Genie programmer in my 2011-2014 Chrysler 300 / Dodge Charger to enable AUTO temperature control and it's not working.
Q: I installed the C-ACC-LD OBD Genie programmer in my 2011-2014 Chrysler 300 / Dodge Charger to enable AUTO temperature control and it's not working. A: If the programmer's embedded LED turned green then the vehicle's computer has been programmed. ...