Jeep Spare Tire Camera Reverse Image

Jeep Spare Tire Camera Reverse Image

Jeep Spare Tire Camera Reverse Image

If you have a camera where the left side of the screen is showing the right side of the vehicle the camera is most likely configured for front facing camera.

To reverse the image to rear view, and also have your grid lines appear you will need to cut the white, and green wires that are located near the first black connection on the camera.
If you start from the camera, and follow it down the wire you should see these wires shortly before you reach that first black connection. 


Grid line options: Default setting is to display grid lines. To remove the grid line display, connect the two green wires near the end of the camera harness. 

Display options: (Not to be used in this application!) Default setting is mirror image display for rearward facing camera (rear view) installation. To change to non mirror image for forward facing camera (front view) connect the two white wires near the end of the camera harness.




 This also depends on the way the camera was manufactured. Some of the newer models do not feature those loops. In this case, the customer can reach out to Brand Motion for further assistance. We have worked with them before in this case, and they asked us to direct any such cases over to them.


    • Related Articles

    • Wrangler Back-up Camera Backwards or Upside down Image

      There have been a few reports of the camera image being in reverse for the Wrangler Back-up Camera Kit. I took a moment, and rotated all of the cameras to the correct position, but I did not cut either of the wires. So it's possible that the next set ...

    • Enzo C-INT4CK Instructions

      FCA Heated and Ventilated Seat including Heated Steering Wheel Emulator (C-INT4CK) For those who upgrade to the 8.4" radio and their heated/cooled seats & heated/cooled steering wheel in the new radio are grayed out, we have a solution. Example of ...

    • C-INTC3T RE2 RB5 Camera Repining Guide

      C-INTC3T RE2 RB5 Camera Repining Guide If your RB5 or RE2 radio already has the C3 connector with populated wires like the photo below, you will not be able to use our connector because you will lose audio and microphone for bluetooth functions. You ...

    • Denso: No Backup Camera (No Change In Reverse)

      Denso: No Backup Camera (No Change In Reverse) If you are unable to get your backup camera to come on, you will need to go into the setting and select: Backup Cam > Settings > Enable

    • C-INTC4T to U-INTRCA (If customer receives C4T instead of U-INTRCA in Uconnect 5 Cargo Camera Kit)

      If you ordered a cargo camera and got a C-INTC4T but you have a Uconnect 5 radio installed in your vehicle then you need U-INTRCA to connect the cargo camera to the radio. The C-INTC4T is make for the Uconnect 4 radios. You can cut the female RCA off ...