JEEP Wrangler JL Rear Park Sense (Sensors are reversed)

JEEP Wrangler JL Rear Park Sense (Sensors are reversed)

JEEP Wrangler JL Rear Park Sense (Sensors are reversed)

If the sensors are reacting on the instrument cluster reversed... Such as an object or person on the rear-right side of the vehicle but the instrument cluster saying the object or person is on the rear-left side, then there are two possible causes.

The first, is that the wiring for this kit must be performed around the front passenger side, down the right side of the vehicle, then to the bumper where the last sensor connector will be on the far left side. If the wiring wasn't followed in the installation video and went from the driver's side, then the sensors are ran in reverse.

If the installation was followed to the video, where it runs down the right side (not driver's side) then there is a small pinning procedure that needs to be performed. The pins are reversed and must be changed.

This will require a de-pinning and re-pinning procedure. This connector will require pinning tools to remove the wire. If this appears to be too difficult, please reach out to Customer Support and we'll need to exchange the harness with one that is properly pinned, but unfortunately you will have to undo the wiring that you had already ran. This article was created to avoid having to do an exchange which results in taking longer to getting this upgrade working as intended.

Pin 1 and pin 5 need to be reversed. (Signal 8 and 11)

Pin 2 and pin 3 need to be reversed. (Signal 9 and 10)





Alternatively if depinning is incredibly difficult, The wires can be chopped and soldered/posi-tapped to the correct wire. This is to be done at your own risk, because we won't be able to warranty a destroyed harness, we will need to sell a replacement harness.

    • Related Articles

    • Can't control climate on 8.4 Jeep Wrangler screen upgrade

      Can't control climate on 8.4 Jeep Wrangler screen upgrade After installing an 8.4 inch screen upgrade, if you've noticed that you can control your climate on the hard knobs but not the touchscreen, it's because your stock climate control is analog. ...

    • 2018-2023 Jeep Wrangler JL Factory OEM Mopar Passive Entry Keyless Go Upgrade Harness Pinning Guide

      2018-2023 Jeep Wrangler JL Factory OEM Mopar Passive Entry Keyless Go Upgrade Harness Pinning Guide When installing the wiring harnesses for the Passive Entry Upgrade, you may notice the video's harnesses are slightly different than the harnesses ...

    • Wrangler Back-up Camera Backwards or Upside down Image

      There have been a few reports of the camera image being in reverse for the Wrangler Back-up Camera Kit. I took a moment, and rotated all of the cameras to the correct position, but I did not cut either of the wires. So it's possible that the next set ...

    • Jeep Spare Tire Camera Reverse Image

      Jeep Spare Tire Camera Reverse Image If you have a camera where the left side of the screen is showing the right side of the vehicle the camera is most likely configured for front facing camera. To reverse the image to rear view, and also have your ...

    • Enzo C-INT4CK Instructions

      FCA Heated and Ventilated Seat including Heated Steering Wheel Emulator (C-INT4CK) For those who upgrade to the 8.4" radio and their heated/cooled seats & heated/cooled steering wheel in the new radio are grayed out, we have a solution. Example of ...