My Radio Doesn't Turn Off After Shutting Off the Vehicle
My Radio Doesn't Turn Off After Shutting Off the Vehicle
There is a delay in powering down the radio built into the software.
The default setting is 45 seconds after the key is out of the ignition and the door is locked.
You can change the delay in the radio settings to zero seconds after powering down the vehicle.
Related Articles
The navigation display doesn’t accurately follow me down the highway/Issue with hearing turn-by-turn directions
The navigation display doesn’t accurately follow me down the highway/Issue with hearing turn-by-turn directions If you're having any of the issues below, you may need to install the VSS kit (brown connector) which should have been included in your ..."Radio Locked Please Start Vehicle"
"Radio Locked Please Start Vehicle" If you are receiving this message, then you have either a Chrysler 200, Jeep Cherokee, Jeep Renegade or a Jeep Compass. These two vehicles use a Fiat based computer system and will need to have the vehicle's ...RADIO DOES NOT POWER ON AFTER I INSTALL MY UPGRADE KIT
If you installed your upgrade kit and notice that your radio no longer turns on please check the followings: 1. If you received a C-INT-C4T (the big harness that connects to the radio and existing power harness) in your kit, make sure that the white ...Uconnect Radio Just Installed - Acclimation Period upon Installation
All Uconnect Radios require an acclimation period for the BCM and the Radio to handshake. Older generation Uconnects, such as the Mygig RER/RHR/RHB/RBZ just need a couple of key cycles if the wrong splash screen / Logo shows up (Vehicle is a RAM, but ...2016 - 2020 Toyota Tacoma Entune 3.0 Radio doesn't get any audio
2016 - 2020 Toyota Tacoma Entune 3.0 Radio doesn't get any audio After installing this upgrade, and allowing the vehicle to sleep up to 48 hours, if there's no audio then check to see if there's a JBL logo on the vehicle's radio fascia. If so, that ...