“Proceed to the highlighted route” and “You’ve reached your destination”.

• Related Articles

• Can't navigate multiple camera inputs with UAQ/UAS upgrade

  If your vehicle has multiple cameras, such as a reverse, cargo and front camera, and you have the appropriate hardware to route which camera image appears in your radio head-unit's screen, note that not all of these functions will be retained when ...

• The navigation display doesn’t accurately follow me down the highway/Issue with hearing turn-by-turn directions

  If you're having any of the issues below, you may need to install the VSS kit (brown connector) which should have been included in your kit along with a set of pictured instructions.  Not all vehicles require a VSS kit.  If you vehicle already have ...

• My steering wheel controller is not working with the new system.

  In the Brick Kit should be a new steering control module. Make sure that you replace your existing steering wheel controller with the one provided. If it is still not working, then try using your original controller. We’ve found that with some ...

• HVAC plug missing from main harness (4" to 8" upgrade only)

  The design of the harness was changed recently. The red plug that would've been installed in the bezel behind the HVAC panel is no longer required. Please proceed with the rest of the installation.

• UAQ / UAS requesting update after install

  After installing your Infotainment UAQ or UAS upgrade, if you had an 8 inch screened-unit in the vehicle before, over the air updates will still be retained. Please proceed forward once met with this message: