"Radio Locked Please Start Vehicle"

"Radio Locked Please Start Vehicle"

"Radio Locked Please Start Vehicle"

If you are receiving this message, then you have either a Chrysler 200, Jeep Cherokee, Jeep Renegade or a Jeep Compass.

These two vehicles use a Fiat based computer system and will need to have the vehicle's dealership perform a Proxy Alignment for the option code of the unit you purchased, either RA3(VP3) or RA4 (VP4).  

This can be done at any Chrysler Dodge Jeep or Fiat dealership.

This is stated on the the product page under the Installation:


    • Related Articles

    • The elements that will prevent remote start from working

      Ensure that your vehicle is not doing any of the following in order to allow the remote start upgrade to work: -If the engine stalls or RPM exceeds 2500 -Any engine warning lamps come on -The hood is opened -The hazard switch is pressed -The ...

    • Enzo C-INT4CK Instructions

      FCA Heated and Ventilated Seat including Heated Steering Wheel Emulator (C-INT4CK) For those who upgrade to the 8.4" radio and their heated/cooled seats & heated/cooled steering wheel in the new radio are grayed out, we have a solution. Example of ...

    • 2018 + Vehicles With ESS, or Engine Start Stop

      2018 + Vehicles With ESS, or Engine Start Stop If you have an 18+, or any vehicle with engine start stop feature you will most likely have a second battery in the vehicle. If you do have a second battery please do not perform a CAN-BUS reset. You are ...

    • Uconnect Radio Just Installed - Acclimation Period upon Installation

      All Uconnect Radios require an acclimation period for the BCM and the Radio to handshake. Older generation Uconnects, such as the Mygig RER/RHR/RHB/RBZ just need a couple of key cycles if the wrong splash screen / Logo shows up (Vehicle is a RAM, but ...

    • RADIO DOES NOT POWER ON AFTER I INSTALL MY UPGRADE KIT

      If you installed your upgrade kit and notice that your radio no longer turns on please check the followings:  1. If you received a C-INT-C4T (the big harness that connects to the radio and existing power harness) in your kit, make sure that the white ...