Ram Cab Mounted Lighting Pin out for Uconnect Mirror replacement

If you have a Cab mounted light, and are changing your rear view mirror to the Uconnect Microphone Mirror you will need to switch some pins to retain functionality of the cab lights. 

You just need to pin the power, and ground into the new harness, so the lights continue to power on with the vehicle.

Pin outs Below

• Related Articles

• Voice Recognition Not Available / UConnect not available error with Handsfree microphone on RER or RHR

  After installing your UConnect Handsfree Microphone into your RER or RHR headunit, and trying to set up voice recognition, if you receive and error stating "Voice recognition not available. UConnect not available," do the below following steps to fix ...

• UConnect Cannot Hear My Voice

  If you have paired your device to the unit, but you cannot be heard on a phone call, or the unit isn't receiving voice commands, please check your UConnect Microphone setup. Ram trucks with an RA2, RA3 or RA4 8.4" screen might require a Ram UConnect ...

• 19 + New Body Ram Mirror Installation

  If you are having trouble following along the video on a New body ram than please refer to the attached PDF files for Dodge's official instructions on how to remove the door panel, and Mirror for this installation.  These will be the same ...

• RAM Only--The Replacement USB Hub Does Not Fit Properly

  This is due to the fact that there is only one Apple Carplay-compatible hub for the Dodge Ram and it's designed for 2018 vehicles. Please see the hub's install video for further information: ...

• AC Climate control visual bug on Ram 1500

  Parts Required Two Genies labeled LD, and DS Wire connector that you will use to connect the sensor Temperature Sensor Security bypass if you are an 18+ year Installation Attach the sensor wire to the open molenex connector on the harness that is ...