Sync 1 With separate screen Camera installation

The interface will plug into the back of the ACM, or CD player in this case, and NOT the screen.

This is where you plug the interface in, and you will just connect your factory plug into the female end of the connection

• Related Articles

• Time won't set for non-Nav Sync 3

  Despite not having navigation programmed to the APIM module, for the non-Nav version of Sync 3 upgrades, all APIMs use a GPS antenna to set time. If time will not stay, when set, check your GPS antenna and make sure it's plugged into the ...

• Sync 4 Screen is Glitchy / Back-up Camera Does not appear in Reverse

  Problem: Customer's Sync 4 display screen is glitchy or the backup camera does not appear when in reverse. Possible Resolution: Disconnect the supplied harness and reconnect to the factory plugs. Ensure the yellow RCAs are securely connected. Test ...

• Display not showing but rear camera does in a GM vehicle

  This is caused by a faulty ACM, and the ACM will need to be replaced. It doesn't matter if the HMI is a 2.0 or 2.5, it would still work.  This is illustrated when the vehicle is put in reverse and shows a picture, meaning HMI & screen are ok. The ACM ...

• Sync 3 upgrade gives Navigation Fault

  This issue arrives if the Sync 3 upgrade doesn't have our infotainment GPS antenna plugged in upon start-up: To resolve this, always plug in the GPS antenna we supplied you BEFORE turning on the unit/vehicle.

• When screen experiences imaging issues other than back up camera in Chevy vehicles

  In Chevy vehicles, your HMI (Human Machine Interface) controls your visual feedback. Meaning if you experience an issue where the screen is having imaging issues only during certain functions, it may be the HMI, however, if the back up camera has a ...