Time won't set for non-Nav Sync 3

Time won't set for non-Nav Sync 3

Despite not having navigation programmed to the APIM module, for the non-Nav version of Sync 3 upgrades, all APIMs use a GPS antenna to set time. If time will not stay, when set, check your GPS antenna and make sure it's plugged into the circular-pinned plug behind the APIM.

    • Related Articles

    • Sync 3 upgrade gives Navigation Fault

      This issue arrives if the Sync 3 upgrade doesn't have our infotainment GPS antenna plugged in upon start-up: To resolve this, always plug in the GPS antenna we supplied you BEFORE turning on the unit/vehicle.

    • Toyota Tacoma Entune 3.0 won't set clock or tracking miles/kilometers

      Toyota Tacoma Entune 3.0 won't set clock or tracking miles/kilometers If your new Entune 3.0 radio doesn't allow you to press on the time and set the clock or miles or kilometers don't track or allow change, that's related to the GPS connection. Make ...

    • Sync 1 - How to get GPS to work, troubleshooting.

      For Sync 1 radios, aka Clarion radio for Ford, when first installing these radios the GPS will not work right off the bat most of the time. You will need to clear the radio's DTCs then drive around for a few days to get at least 8 satellite signals ...

    • 2019 - 2020 Ford Transit APIM location

      The APIM is located behind the glovebox:

    • Sync 3 Upgrade: GPS Isn't Accurate

      If your GPS location isn't accurate when viewing the navigation, your instrument cluster will switch between two directions (N & S), and possibly showing you driving relatively close, but may be haywire at times, please see below: This is a cluster ...