UAV/UAX windshield wipers won't stop after installing unit/Genie
UAV/UAX windshield wipers won't stop after installing unit/Genie
Please have your vehicle completely turned off, or battery terminals removed, during the installation process of your retrofit upgrade.
If you install this with your vehicle on or in accessory and try to use the Genie, even if it gives you a green confirmation light, there is a possibility you blow a fuse or relay in your vehicle because the battery wasn't disconnected before starting upgrade.
The common symptom this causes is your windshield wipers going off constantly. You may also experience bezel control issues as well.
If unable to isolate the affected relay or fuse, please to to a local dealer to have the vehicle looked at.
Related Articles
UAX / UAV doesn't give display
UAX / UAV doesn't give display After installing your UAX or UAV upgrade, if you notice that you have a black screen. This is caused by one of two issues: The Genie didn't produce a green LED to properly program the vehicle to turn on the radios ...
UAV to UAX Retaining Sirius Guardian / UConnect Access
UAV to UAX Retaining Sirius Guardian / UConnect Access When upgrading from an UAV to UAX, you will retain Sirius Guardian / UConnect Access, due to already having the necessary 4G antenna. You will need to reach out to Sirius Guardian to have the ...
2019 Heavy Duty UAV or UAX Upgrade Climate issue
Since last year we've had an issue where a 2019+ Ram truck customer (who has installed either a UAV or UAX upgrade) increases or decreases their cabin temperature around 70-74 degrees the vehicle either goes full heat or full cold. This happens ...
IOB Genie gave green light but screen is black
This Genie puts the radio into sleep mode while it's programming. This means, after the Genie gives a green LED light, if it's pulled out immediately, the radio screen will stay black. After turning on the vehicle's engine, letting it run 1 minute, ...
OBD Genie Troubleshooting Guide
OBD Genie Troubleshooting Guide Following this simple instructions is the first steps to getting you back on the road with all the new modifications. My OBDGenie is not doing anything. No lights appear when plugged in, I can't tell if it's getting ...