UConnect Jumper Kit Information

UConnect Jumper Kit Information


Product page can be found by clicking on this link


The UConnect Jumper kit is designed to allow you to retain use of your factory microphone when upgrading to an RER or RHR navigation radio.  



For the RER, the jumper cable is used, the USB cable in the kit is only for the RHR radio.  



Jumper Kit Installation Video




Quick Instruction Guide: 

Step 1 : Locate your UConnect module and disconnect both cables as pictured.



Step 2: Join the disconnected UConnect module cables to the UConnect Jumper Kit female plugs.



Step 3: Join the UConnect Jumper Kit male plugs into the rear of the RHR radio.


•You will need to re-pair your phone to your newly installed 730N RHR after installing this kit.








Attached below is the PDF that is available on the product page which has additional information.


    • Related Articles

    • UConnect Cannot Hear My Voice

      If you have paired your device to the unit, but you cannot be heard on a phone call, or the unit isn't receiving voice commands, please check your UConnect Microphone setup. Ram trucks with an RA2, RA3 or RA4 8.4" screen might require a Ram UConnect ...

    • Uconnect 5 not saving radio presets.

      For the Uconnect 5 radio upgrades. Sometimes the new radio will not save the AM/FM radio presets saved by the customer. Customer will save presets and after a short time with the vehicle on the radio will remember the presets but if the vehicle sits ...

    • UConnect Requiring MDN for UConnect Access Transfer on 8.4 UA Radio Upgrade

      While UConnect almost never wants to transfer over UConnect Access to a newly installed radio, you'll sometimes talk to a Tier II rep that will try to accommodate your request. They will ask for an MDN number that can only be found in the settings of ...

    • Will SRT Pages Be Retained After Upgrading to a UConnect 4 Radio

      When retrofitting your Chrysler-based vehicle with a UConnect 4 radio, if vehicle came of the lot with SRT pages, that code will transfer over to the new radio. After installing the new radio, it will not show immediately, it will require several ...

    • Voice Recognition Not Available / UConnect not available error with Handsfree microphone on RER or RHR

      After installing your UConnect Handsfree Microphone into your RER or RHR headunit, and trying to set up voice recognition, if you receive and error stating "Voice recognition not available. UConnect not available," do the below following steps to fix ...