C-INTC4T to U-INTRCA (If customer receives C4T instead of U-INTRCA in Uconnect 5 Cargo Camera Kit)
If you ordered a cargo camera and got a C-INTC4T but you have a Uconnect 5 radio installed in your vehicle then you need U-INTRCA to connect the cargo camera to the radio. The C-INTC4T is make for the Uconnect 4 radios. You can cut the female RCA off of the C-INTC4T to make the U-INTRCA with two posi taps from your local hardware store. Below is instructions on what you need to do.
Cut the yellow and black wires as close to the plastic as you can, wire cutters are handly.
Once you have the female RCA out, strip the wire about an inch back, the copper around the yellow wire is the ground. Twist the copper wires together and strip the tip of the yellow wire. Add posi tap to each wire and secure it all with some heat shrink or electrical tape.
Congratulations! You have made yourself an U-INTRCA! Tap into the blue connector on the rear of the Uconnect5 radio.
Related Articles
2022+ Uconnect 5 Cargo Camera Posi-Tap Guide
If you have a Uconnect 5 system, then you will be receiving a pigtail adapter with a yellow RCA and two posi-taps. Red is the Camera Signal, and Black is the Camera Return. You will be tapping to the Blue connector on the back of the radio unit. The ...
Cargo Camera Not Showing Up On Screen
Cargo Camera Not Showing Up On Screen If you're having issues with your VP3 (RA3) VP4 (RA4) Infotainment system not showing the Cargo camera, or you're not sure how to access it, please continue below: Your unit may appear to visually look ...
UConnect Jumper Kit Information
Product page can be found by clicking on this link The UConnect Jumper kit is designed to allow you to retain use of your factory microphone when upgrading to an RER or RHR navigation radio. For the RER, the jumper cable is used, the USB cable in the ...
360 Camera Module Locations
When a customer has to replace their 360 Camera module in their vehicle after upgrading to a Uconnect 5 radio, there are two locations for the 360 module. In the 1500s it is located behind the passenger side kick panel. Once removed you'll see the ...
UConnect Cannot Hear My Voice
If you have paired your device to the unit, but you cannot be heard on a phone call, or the unit isn't receiving voice commands, please check your UConnect Microphone setup. Ram trucks with an RA2, RA3 or RA4 8.4" screen might require a Ram UConnect ...